It will have a different software configuration. 3) Following on from 1 above, if there is a problem with the filler cap sensing (magnet, sensor, wiring), then the FACM may be unable to be fully reset. Forscan or ELMConfig can, I think, monitor the operation of the filler cap sensor. KFzO72W. Is there a link for correct forum covering injector issues. Mk4.5 2011 2.0 163 tdci injector no.3 puffing. Smoking leaking. Took it to an engine specialist in Teesside who I won,t mention but they removed no.3 injector. New seal. Replaced injector. Now the engine is tapping like a bag of spanners. Took it back. On idle they were between 0.9 - 1.08, at 2000 RPM +/- 100 the rates of all cylinders were 1.00000079. Other facts - no problems in starting no matter if it is cold (-13 C) or hot, fuel consumption is normal, I haven't noticed any running issues except very slight RPM oscillation at idle. Rampa Presiune Injectoare cu Senzor Regulator Ford Focus 2 1.8 TDCI 2004 - 2010 Cod 4M5Q-9D280-DA. 99,99 lei. For 1.8 TDCi and 2.0 TDCi engines the each injector has a 16-digit calibration code stamped on the body. For 1.6 TDCi engines the each injector has an 8-digit calibration code stamped on the body. These codes relate to the electrical and structural characteristics of each injector,which are defined during production. Ford Focus tdci - Focus focus tdci 1.8 2007 non starter. 2007 focus tdci 1.8 non starter Hi all. First post so be gentle :) I have a mates' focus 1.8 tdci here which is failing to start. Seems to be lack of fuel. Have changed fuel filter and seals and also 4 glow plugs as I'm reading a glow plug fault. 2002 Ford Focus TDCi 115 - Lumpy idle after injector recode - elekie&a/c doctor : The injector coding is unique to each injector.If the original injectors were refitted to the engine in the same order that they were removed, then the same codes would be entered into the engine ecu.If different injectors were fitted,then the injector re-programming sequence would need to be carried out.From the

ford focus 1.8 tdci injector coding